Tossing my hat in the ring just to keep an eye on this thread... thinking of a way to fab up a threaded bushing on the speedway arms to give them a limiter. Drop some weight and add a limiter for not much $$...
speedway motors tubular control arms
- Thread starter t72ss402
- Start date
I am working on a bump stop right now that will bolt on.....A fab shop is cutting it out as we speak. I will show you what we did with mine when it's done...
You use the RIGHT side arms on our street cars to eliminate the need for excessive shims (which can push the factory a-arm into the pass header under full articulation, or be very close to your steering shaft on the drivers side). I went looking for this post to update after my alignment after installing my Speedway arms 1-1/2yrs ago (both RIGHT side). They have been doing just fine. I decidedf to finally get down to the alignment shop last week. You may not believe this, but my car required NO shims. I didn't believe it, but I was in the bay with him and read the machine for myself and saw the results.
Similar threads
