Wiring a Oil & Trans Temp Auto meter gauges

[ontariomal]

for transmission temp as it was said it usualy goes on the side of the pan, bm deep pans have threads for the sender already in the pan.

Oil temp i always seen on the oil pan as well like it was said welded bung and screwed in. As for the wiring you just need a wire from the sender to the gauge and you can either wire into the factory guage harness like i did, or just take a wire and put a spade connector on the end and plug it into one of the spots on the front of the fuse box labeled IGN

Do all the B&M Deep Pans come with Temp senders?? I checked their site they speak about drain plugs, but don't mention threads on the side of the pan for sender... I was looking at the cast aluminum pan.

 

[iwannawheelie]

B&M 30280

This i the pan ordered for my buddy and it had provision for the temp sender.

 

[ontariomal]

B&M 30280

This i the pan ordered for my buddy and it had provision for the temp sender.

Thank you, that was the pan I was looking at buying.

 

[ontariomal]

Not to sound lazy or dumb, but does this mean that I'm going to have to remove my oil pan in order to install the temp sender??

Is there another way???