I have not posted here in a really long time. I have a 79 Malibu that I have had for years. I originally installed a LT1/700r4 out of a 93 Firebird. Lost interest so I built a vortec 355 with a 200r4 which I am installing after some time. I installed engine/trans, built and installed a new trans crossmember, reworked the fuel system for a carb. The headers and starter are installed. I found a drive shaft, swapped the u-joints and installed it. The drive shaft safety loop is rubbing the bottom of the drive shaft. The transmission seems to be low. I changed motor mounts during this install and may have made a mistake...
Can anyone tell me the distance from the inside of the trans tunnel to the top of the output of the 200r4 is. I am about 4" to 4.5" now. Will anyone measure and see if this is correct or at least ballpark before I built another drive shaft safety loop? I would really appreciate the help!!!
Can anyone tell me the distance from the inside of the trans tunnel to the top of the output of the 200r4 is. I am about 4" to 4.5" now. Will anyone measure and see if this is correct or at least ballpark before I built another drive shaft safety loop? I would really appreciate the help!!!