I was driving my car today and my engine started squeeking and I've heard this very distinct squeek before and I know what it is. So I shut off the engine as fast as I could and pulled over and towed my car home. I was wondering if anyone has changed there bearings with the motor still assembled. Basically the motor has less than 5000 miles on it and it is a 388 SBC with AFR eliminator heads. I'm hoping to just take the engine and trans out of the car and with it in the air take the pan off and take the caps off and inspect the crank. If there is no significant damage I would like to just swap the bearings and put the motor back in and try it again. Any suggestions or feedback would be appreciated!