It didn't come in until yesterday. We tried some test fitting last night. It clears the crossmember fine. I'm not sure about how low it is going to hang at this point. When I was dropping the motor in for test fit, I noticed the passenger side frame mount was VERY worn. It definitely needs replacing. So, I could not get it properly positioned to see how low the pan will hang. I'm guessing it is going to be close to 1/2" - 1" below the crossmember, but that is nowhere near as bad as the truck pan. The front of the sump on the pan looks like it might have 1/2" clearance to the crossmember. It is very close, but it fits fine. Also, there is no clearance problem with the slope of the pan either. Again, it's pretty close, but doesn't appear to be a problem. I will know more after I get the motor mounts replaced. I plan to get it done this weekend, and shoot pictures.