Pulled a bone head move when I took motor and trans out. I left the linkage hooked up where It drops down through the floor on my 64 chevelle....when I reinstalled it I had to use a pry Bar to get it to hook back up (trans linkage )... I went to drive it and it shifted hard had to play with it to go into gear. I've backed it in and out of the garage a few times now and it seemed better. This weekend I went to pull it inside and it acted up again. I had to forcefully try n shift it. Now it's messed up . I rolled it in the garage with it in the park postion . (Inside the car) I took console apart and unhooked the rod that goes to the arm through the floor. Shifter goes through the motions as it should. So I know the issue is down below. I can't seem to get it into park manually by hand...what should I do?