I just recently put a TH400 in my car and I'm having some issues with the output shaft of the transmission being a little too low. It has the drive shaft in a spot to where the yoke and the drive shaft are making a "V". Its not horrible by any means but bad enough to where I added a spacer between the trans and the mount, which cured a lot of the problem. It didn't fix it 100% so I still have to do something different, and I was wondering if anyone else has encountered this problem with a 400 trans?
To give a little more info, my car has a LS1 with the engine/transmission set back 1''. I also have solid rear suspension so I can't adjust it to gain some pinion angle.
I figured I'll be stuck with buying some adjustable rear suspension pieces, but there might be something I'm over looking too?
To give a little more info, my car has a LS1 with the engine/transmission set back 1''. I also have solid rear suspension so I can't adjust it to gain some pinion angle.
I figured I'll be stuck with buying some adjustable rear suspension pieces, but there might be something I'm over looking too?