G Body Elcamino Roll cage help Needed

rwolf15241

Daily Driver
Feb 9, 2013
47
0
0
Pittsburgh, PA 15241
G Body Elcamino Roll cage help Needed

Looking to install a Jegs 6 point roll cage, to stiffen the frame.

1. Box & notch frame .
2. Front Roll Bars, Jegs Pro Touring follows seat height
3. Jegs Main Bar
4. Rear Bars mounting into the storage area.
5. Planning to weld 6 stubs off the frame to pass through the body and bolt to the roll cage.

What do you guys think???

dancin_banana.gif dancin_banana.gif dancin_banana.gif
 

hcky4life08

Daily Driver
Jul 23, 2012
27
0
0
Dayton ohio
I welded mine straight to te frame didn't need to weld tabs of the frame unless you have other ideas or thoughts for doing it
 

LS6 Tommy

MalibuRacing Junkie
May 15, 2004
15,847
1
38
North Jersey
I may be wrong, but I don't think a bolt in cage of your design will pass tech. With "normal" bolt in cages, you have to have a 6" plate above and below the floor of each mounting point. The plate on the inside of the car is welded to the cage. (4) 3/8" bolts through the top plate, floor and bottom plate secure the whole "sandwich".

Tommy
 

rwolf15241

Daily Driver
Thread starter
Feb 9, 2013
47
0
0
Pittsburgh, PA 15241
Not looking to drag race it !!!, just to stiffen the chassis. I don't think it will work any way!!! I'm 6'2 and will bang my head off the bar getting in and out!!
 

MalibuRacing.com Gear

Stickers & Shirts!!