Turn signal bulb in dash replacement

4 or 6 screws to remove the cluster from the dash, and you can access the circuit board that holds all the lamps. Really an easy operation.

Seems like there was a post on here about replacing those lamps...?

If you're skinny and flexible you might be able to reach up under the dash to pull the bulb out, that's the fastest way.

I think Mike's Montes sells brighter dash lights.

Tommy

I suggest that 194 is adequate for turn signal bulbs. 168s will be too bright since they are directly behind the lens.

t5montecarlo said:

I suggest that 194 is adequate for turn signal bulbs. 168s will be too bright since they are directly behind the lens.

Click to expand...

Good point. I wasn't thinking about turn signals. I was remembering gauge lighting.

Tommy

perhaps not making good contact between the socket and the printed circuit. You will need to remove the entire housing or try and get at it from underneath (difficult). While it is out, clean all contacts.

LS6 Tommy said:

I think Mike's Montes sells brighter dash lights.

Tommy

Click to expand...

Do the bulbs they sell really work?