blazer brake , drop spindle question

Time Warp

Dragway Regular
Nov 1, 2006
932
0
0
Titusville , Florida
I'am back in a gbody now . Not a Malibu but a Monte Carlo SS .

I'am wanting to lower the front end 1.5 to 2 inch and get a little better braking . Coil over front way later down the road , after i get a rear end ect.

I been reading about the blazer brake upgrade and if i go this route luckily a friend has a set of 2 inch blazer drop spindles a can work a trade with. i'll need to get new hubs but not a big deal. I've read the spindle push the wheel out approx 3/8 to 1/2 inch per side . But i have read conflicting things about 15 in rims not fitting or tie rod end rubbing with stock upper and lower arms .

Has either of the above been an issue if you run this setup ?
 

StreetBu

MalibuRacing Junkie
Mar 21, 2004
4,158
3
38
Upstate NY
Blazers came with 15" wheels so they should fit....
 

elcaminoss84

Frequent Racer
Sep 26, 2009
336
0
16
Oklahoma
I've had 15inch weld prostars, 16inch gtas and s10 extreme rims and also 17 torque thrust 2s all work with blazer brakes and spindle swaps on gbodys
 

MalibuRacing.com Gear

Stickers & Shirts!!