What did U do to your G-body today??

That's awesome, Congrats!

Taking the gauge cluster off to replace the printed circuit board, to fix the gauge light problem.

Finished getting it off. Removed the printed circuit board. Ordered a new one.

I started to put the new printed circuit board in.

I had to take the cover and shield off the gauge cluster. I have a stainless plate that goes around the gauge face, it came unglued. I'm in the process of regluing it now.

I got the stainless plate reglued. The shield and cover are back on the cluster. It looks good and works.

remembered I owned it and how much that needs to get done to maybe drive it for an event at the latter end of the year

Work on it every day even if it's only for 15 minutes. I know that sounds stupid, but a little at a time will get you there eventually!

StreetBu said:

Work on it every day even if it's only for 15 minutes. I know that sounds stupid, but a little at a time will get you there eventually!

Click to expand...

X2 a little at a time gets it finished.

I pulled the speedometer cable out through the firewall. I was hoping to mount the electronic cruise control under the dash. I then learned it needs to connect at the transmission. In the process I disconnected the tach. So I removed the gauge cluster so I can reconnect the speedometer cable and reconnect the tach. Once I get that accomplished, then I'll put it back together.