Trunk lid torsion bars

Doober

Moderator
Jun 2, 2003
14,704
1
38
Catalina, AZ
www.cardomain.com
Ok, so the kid I bought this from had disconnected the torsion bars for the trunk lid. Does anyone know if there is a special tool for putting them on? I thought I had one side done, but it wasn't seated in the little pivot piece that's on the trunk lid arm itself. I got peeved and quit because I'm too weak :cry:
 

RatMalibu

Pro Stocker
May 21, 2003
2,225
0
0
Rolla, Mo.
www.fidnet.com
I have a foot long piece of 3/4" or so bar stock with a hole drilled at a slight angle at the very end....I also have one that is just 1/4" thick flat bar that's the same way....one or the other gets the job done usually
 

MalibuRacing.com Gear

Stickers & Shirts!!