METAL POLISHING/RE-FINISHING

LIVE4RDO

Frequent Racer
Jul 21, 2010
678
0
0
Staten Island, NY
Hey there crowd,

Looking for some recommendations on a reputable metal polishing/re-finishing place. The closer to NYC, the better.

I want to re-do my windshield, rear window and drip rail moldings, sill panels and visor brackets.

Any one heard of Blue Mountain Metal Finishing in PA?

Thank you, as always.
 

LS6 Tommy

MalibuRacing Junkie
May 15, 2004
15,847
1
38
North Jersey
Paul's Chrome. Only one I use. Not cheap, but good!

http://paulschrome.com/

Tommy
 

81classic

Top Fueler
Jun 5, 2003
2,833
0
0
North Port, Fl
Not sure if he does polishing, but I had all my exterior trim bright dipped & re-anodized by David Russell Anodizing near Orlando, Fl. Did an excellent job. I was going to have the pieces polished, but after testing on some extra pieces decided against it due to the low quality aluminum alloy GM used on these pieces.
I would buy new visor brackets myself as there are still GM pieces available.

http://www.davidrussellanodizing.com/

iphone023.jpg
 

LIVE4RDO

Frequent Racer
Thread starter
Jul 21, 2010
678
0
0
Staten Island, NY
Do you remember how much they charged you? Just to have an idea. I guess re-anodizing might be the way to go.
 

81classic

Top Fueler
Jun 5, 2003
2,833
0
0
North Port, Fl
LIVE4RDO said:
Do you remember how much they charged you? Just to have an idea. I guess re-anodizing might be the way to go.

around $375 which included shipping there and back, that was for the window trim, drip rails, and b-pillar trim
 

MalibuRacing.com Gear

Stickers & Shirts!!