I know there is an easy answer to this question. Im putting a new Moser 12 bolt into my 81. I have the new SS lines. But is there a certain tee that people use when they change to a different rear. The original rear was drilled and tapped and the tee bolted to the housing. Im not sure what to do here. Drill and tap a hole and use the original tee block ? I think it was a banjo type of bolt. Im not even sure if its metric or standard. Get a different type of tee block ? Has anyone got an answer for me out there ?? Pics would help too !!
tee on Moser 12 bolt
- Thread starter Mike
- Start date
You should just be able to use a brass T from an auto parts store. Get one with a mounting hole. I just drilled through the Moser webbing on the driver's side and used a stainless bolt and nylock nut to bolt down the T. Flexline goes from the T to the proportioning valve above it on the bottom of the body.
The part is <$5.
Jim
The part is <$5.
Jim
Similar threads
