Crossmember fabrication

[streettired78]

There used to be a link in Tech for fabbing a dual exhast crossmember, but now I get the dreaded 404. I know enough to weld up a crossmember, but I'd like the reassurance of seeing how someone else has done it in the past. Any links you know of?
Thanks for the help.
Elliot

 

[bigg502]

I made my own in about 2 hours what I did is made a jig out of some long bolts that I welded to the table locating the trans mount and the ends were it bolts to the frame making sure they were level and measured what I needed for a opening after the headers were installed and went to cutting I used a piece if 5 inch pipe and welded it in with some gussets it's not a pro job but it works and it's stout and best of all it was free.

 

[BAD78BU]

post pics of the crossmember so we can see it